Troubleshooting LED Utility Lights Working When Ignition Is On But Turning Off After Starting
Question:
I replaced all the lights on my utility with led lights, with the ignition on all lights work great. When I start the engine none of the lights work any suggestions?
asked by: David U
0
Expert Reply:
It sounds like some sort of ignition issue in the wiring. You will most likely need to have this checked at a service center for them to determine if your ignition switch may need replaced or if there is an issue with the ECU.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Sealed, 4" Round, LED Trailer Stop/Turn/Tail Light, 3-Function, 10 Diode - Red w/ Clear Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Coupler on Trailer for GDC-100
- Q&A: Replacing a GDC100 Surge Brake Actuator
- Q&A: How To Shift A 2021 Jeep Wrangler Transfer Case Into Neutral To Flat Tow
- Q&A: Replacement Brake Actuator for Global Direct GDC-80 Brake Actuator
- Q&A: Longest 5th Wheel Pin Box Based on Front Bolt Holes to King Pin
- Q&A: Bolt Hole To King Pin Measurement For The Lippert 1716 5th Wheel Pin Box
- Q&A: Trailer Lights Available for a 24V System
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: What Exactly is Tongue Weight?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Determining Trailer Tongue Weight