Replacement Auto-Programmable Control Panel For Lippert OneControl Slide Out

Question

Question:

Hello Im trying to find a replace slider controller for my rv, I currently have a LIPPERT COMPONETS SLIMRACK/ FAST AUTO PROGRAM CONTROLLER #697096

asked by: Mark H

0

Expert Reply:

We have exactly what you're looking for!

Check out the:

-Replacement Auto-Programmable Controller Panel for Lippert OneControl In-Wall Slide-Outs # LC26TF.

This is the exact same controller as your current controller and will work great as a direct replacement.

expert reply by: Bryce D

0

Answer 1

I reached out to my contact at Lippert and for the Tire Linc TPMS for RVs and Trailers w/ Signal Booster - Bluetooth - 4 Tire Sensors #LC37VR you were looking at to work you will need to have cell service or be connected to WiFi. I included a video…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

We do; the correct replacement for the 1510000236 is the Replacement Auto-Programmable Controller Panel #LC26TF.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…

view full answer...

Answer 7

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Answer 8

The Replacement Auto-Programmable Controller Panel #LC26TF is the correct replacement for your current Lippert part 366701. I got this information directly from Lippert.

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 11

The newer Chevrolet and GM pickup trucks have a known power deficiency issue with the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras #FCE48TASL-05. There is likely nothing wrong that you did, the problem is the…

view full answer...

Replacement Auto-Programmable Control Panel For Lippert OneControl Slide Out

Product Page this Question was Asked From

Continue Researching