Should Left and Right Hand Trailer Ramp Spring be Used with 200 lb Door
Question:
My UTV trailer ramp weighs app. 200 lbs and I am looking for an assist spring. Will just one spring be sufficient
asked by: Frank K
0
Expert Reply:
For a 200 lb door I would recommend using the right hand spring part # RS16933RH with the left hand side as well with part # RS16933LH and you'd be set. With just one spring it would feel lighter but with two it's going to feel considerably lighter and would be much easier to deal with.
expert reply by:
Jameson C
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Hub for Hammer Blow Hub Part HB732 on Old Trailer
- Q&A: Can Ramp Spring # RS16933RH Be Mounted in Center of Ramp
- Q&A: Trailer Ramp Springs for a 20 Ton Tandem Axle Trailer
- Q&A: Determining Axle Length for 6 Foot 6 Inch Wide Trailer
- Q&A: Can Trailer Ramp Springs # RS16933LH and # RS16933RH Be Width Adjusted
- Article: Trailer Tire Sizing
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Replacement Trailer Clearance Lights for GloBrite 122r/122y
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Where to Position the Trailer Axle?
- Article: Trailer Maintenance Schedule