How to Mount Hopkins Smart Hitch Backup Camera # HM50002 to View Picture Right Side Up
Question:
Looking at the photos in the instructions included with the HM50002 it showed you could have it mounted to the top of the windshield but once turned on the picture is upside down, any remedy for this other than moving the display. When mounting the monitor does it have to be right side up.
asked by: Jim K
Expert Reply:
On the mounting piece of your Hopkins Backup Camera # HM50002 there is a screw that holds the mounting piece in position. If you loosen the screw it will enable the mounting piece to be adjustable and from there you can determine the correct mounting position for your camera.
In the video attached I showed you the location of the screw and how the mounting piece adjusts.
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Swap a Trailer With Surge Brakes to Electric Brakes
- Q&A: Parts Needed To Install Trailer Brake Controller For a 2006 Toyota Tundra With Factory 7-Way
- Q&A: 2018 Ram 1500 Firestone Ride Rite Air Bag Kit Recommendation
- Article: Performance Chips and Modules
- Q&A: How To Select The Correct MORryde AllTrek Equalizer For a Tandem Axle Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can You Convert Tie Down Engineering LP8500 from Disc to Drum