How to Wire a 2004 Toyota Tundra Without Tow Package for Brake Controller

Question:

IM UNDER THE DASH! DOES THIS TRUCK HAVE PLUG IN WIRE HARNESS FOR MY PRODIGY CONTROLLER I PURCHASED FROM YOU?? IF NOT WHERE DO I SPLICE INTO FOR CONTROLLER HOOK UP. DO YOU HAVE A VIDEO ON THIS INSTALLATION? BRAKE STOP SWITCH IS ABOUT IMPOSSIBLE TO SPLICE INTO. I LOOKED AT TWO VIDEOS OF TOYOTA BUT THEY HAVE PLUG I UNDER DASH . I CANT FIND THIS ON MY TRUCK, SO I WOULD LIKE TO SEE HOW ITS DONE

asked by: HANS P

Expert Reply:

We have a video (see link) of the Brake Controller 7 & 4 Way Installation Kit - 10 Gauge, item # ETBC7, being installed on a 1999 Dodge Ram. Although this is not the same vehicle as yours the principle is the same. You will need to find the output from the brake switch that only has power when the brake pedal is pressed. Manufacturers change wire colors a lot so there is no specific answer but your brake switch may be green with a red stripe or green with a white stripe. You will need to verify this with a circuit tester, item # 3808, if needed.

expert reply by: Robert G