Compatibility of Pro Series # PSEJ10000101 Sidewind Swivel Jack with Log Splitter
Question:
will this jack work ok on my log splitter?
asked by: Dee J
Helpful Expert Reply:
The Pro Series jack you mentioned, part # PSEJ10000101 fits trailer tongues up to 3 inches wide and 5 inches tall with tongue weights up to 1000 lbs. It is very likely that your splitter falls within these parameters.
When fully retracted, the distance from bottom of the jack attachment bracket to the ground is 13 inches. You will want to check to see if this height is sufficient. Hitch the log splitter to your vehicle and measure the distance from the underside of the trailer tongue to the ground. This jack will work just fine if the distance is greater than 13 inches.
To see a product demonstration video featuring this jack, click the provided link. I have also linked you to our FAQ article that contains more information about trailer jacks.
Product Page this Question was Asked From
Pro Series Snap-Ring Swivel Marine Jack - Bolt On - Sidewind - 10" Lift - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Pro Series
more information >
Continue Researching
- Q&A: Recommended Spare Tire for a Ironton Trailer
- Q&A: Brake Assembly Recommendation for 2005 Wells Cargo Cycle Wagon Trailer with Dexter 3500 lb Axle
- Article: Replacement Automotive Lighting
- Q&A: Appropriate Wire Gauge For Trailer Wiring
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for 2019 Ram 2500 Without Prep
- Q&A: Common Torque Specifications for Lug Nut Size
- Q&A: Can 4.80-12 Tires Be Upgraded to 5.30-12 Tires
- Q&A: Replacement Tire Options For a 165SR13 Trailer Tire
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Jacks
- Article: Most Popular Wheel Bearings