Tandem Axle Hanger Kit # APT9 Recommendation for a Homemade Trailer
Question:
I purchased a homemade trailer. The hangers and equalizers are worn out. It currently has 2inch tall hangers front, center, and rear, and 7inch equalizers with mono leaf springs. I am told it has 9000 lb axles. Based on the pictures of the springs you have online they are 6000 lb. springs. The springs are 1-3/4inch the hangers are 2. Can I use your APT9 which has 2-1/2inch hangers and a 7-3/4inch equalizer? What is the reason for a taller center hanger and does a longer equalizer require the front and rear hangers to be mounted further apart? I have not found these questions addresses in your help section.
asked by: Art G
Expert Reply:
The suspension kit that would be the closest to what you have on your trailer would definitely be the Tandem-Axle Trailer Hanger Kit # APT9. The minor dimensional differences would not cause an issue.
Since the equalizers would be 3/4 of an inch longer I would recommend you compensate for that with hanger spacing.
The distance on center between the spring hanger bolt holes for dual axle setups, with the # APT9 Tandem-Axle Trailer Hanger Kit, should be 29-1/2 inches for double eye springs that measure 25-1/4 inches on center between the spring eyes and for axles that are 3 inches in diameter. This will put your axle spacing somewhere between 33-1/2 and 34 inches.
Products Referenced in This Question
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear/Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Product Page this Question was Asked From
6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Trailer Leaf Springs
- Double Eye Springs
- 4500 lbs
- 1-3/4 Inch Wide
- 6 Leaf
- 26 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Tire Sizing
- Q&A: Replacement Dexter Equalizers for 2-1/2
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Q&A: Replacement Pin Box for Lippert Rhino Box 21k on 2021 Cedar Creek 31IK
- Article: How Long Can You Boondock in an RV?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Q&A: Does Trailer Breakaway Battery have to be Charged for Truck to Sense Trailer Connection
- Q&A: Can the Trailer Breakaway Battery be Used to Power a 12 Volt Interior Light