Reflective Tape Recommendation for Car Hauler Trailer

Question

Question:

I think I've got the lights figured out on my car hauler trailer but now I'm needing to add some reflective tape. Do you have some that will work for me?

asked by: Ian S

0

Expert Reply:

We do! It sounds like you're needing the 3M 7-Year Conspicuity Tape, Red and White # 67636 which is 2" wide and comes in a 150' roll. Attached is a photo another customer sent in who used it for the same scenario as yourself!

This tape features a 7-year warranty so you know it will do a great job at holding up over time. Just be sure you install it on a clean surface.

expert reply by: Jon G

0

Reflective Tape on Car Hauler Trailer
(click to enlarge)

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 5

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Answer 6

The Ranch Hitch Universal 5th-Wheel-to-Gooseneck Coupler Adapter #AM3100 measures 4-1/2 inches in diameter on the outside and the Safety Chains #AM3109 fit around the adapter, as you can see in the accompanying photo. So as long as your gooseneck…

view full answer...

Answer 7

Though the design is slightly different you can use the Camco Horizontal 2-Stage Propane Regulator #CAM59323 in place of the Cavagna Model 524AS 2-stage regulator. I have linked a video review of this regulator for you.

view full answer...

Answer 8

As long as the outer diameter of the gooseneck hitch tube you have is 4-1/2 inches the #AM3109 would fit as that's the size it was designed to fit.

view full answer...

Answer 9

Yourr trailer's coupler uses set screws to hold the tube in place instead of a cross pin. In this case you'll still use the set screws in the same fashion they're being used to install the Extend-A-Goose #BWTEXA4200 and you won't use…

view full answer...

Answer 10

We only carry the springs for those heavy duty style ramps. For the springs we have the Ramp Spring - 2K Torque for 1-1/2" Shaft - left hand #RS16933LH and corresponding right hand #RS16933RH. The other parts will need to be either straightened…

view full answer...

Answer 11

Yes, the DeeMaxx Disc Brake Assembly #DE89YR will fit on a 3,500lb UFP axle. You may need a different Grease Seal #168255TB depending on the age of your axle. If you have a grease seal with a 1.68" inner diameter this is the seal you will need.

view full answer...

Answer 12

As long as your horse trailer features a 4 inch diameter outer tube (which is pretty standard) the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 that you referenced will work really nicely to replace its inner tube. It will provide a 10 inch…

view full answer...

Reflective Tape Recommendation for Car Hauler Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching