Distance Between Holes on TorkLift SuperHitch Original Trailer Hitch Receiver TLC1201
Question:
I want to put a super hitch receiver on my 2009 bluebird school bus so I can tow a car behind. I already have the extension for it as I have a 4foot porch on the back. I need to know the width of the bolt holes to see if it will fit the frame.The extension I have has the 2- 2. thanks
asked by: Wayne R
0
Expert Reply:
The distance between the mounting holes on the TorkLift SuperHitch Original Trailer Hitch Receiver part # TLC1201 is 34-1/2" left to right on center. I have attached a photo below as well.
expert reply by:
Conner L
0
Product Page this Question was Asked From
TorkLift SuperHitch Original Trailer Hitch Receiver - Custom Fit - Class V - Dual 2" Receivers
- Trailer Hitch
- Custom Fit Hitch
- Class V
- 1700 lbs TW
- 17000 lbs GTW
- 20000 lbs WD GTW
- 2 Inch Hitch
- 2000 lbs WD TW
- Visible Cross Tube
- TorkLift
more information >
Continue Researching
- Q&A: Does it Matter Which Receiver is Used for Towing with a TorkLift SuperHitch Original Hitch
- Q&A: Universal Trailer Hitch Receiver For Chevrolet 3500 With a Repaired Frame
- Q&A: Does Torklift SuperHitch Require Different Rear Tie Down than Stock Hitch
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: What is the Height of the Side Mounting Brackets for the Curt Class V Trailer Hitch # C15317
- Q&A: TorkLift SuperHitch Fit on 2012 Ram 3500 With Factory Hitch Welded On
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: Recommended Trailer Hitch for 1976 Chevy C/K Series Pickup with Drop Receiver
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Will Curt Trailer Hitch # 13339 Fit 2000 Chevrolet Silverado 2500 w/ Knapheide Utility Bed
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Mount a Truck Bed Camper
- Article: Determining Trailer Tongue Weight
- Article: 5 Things to Know About Weight Distribution Hitches