Dimensions of Inside Arch on Spring Seat for Typical 8,000-lb, Round Trailer Axles
Question:
Would like to know the measurement of the opening of the arch horizontallyinch if possible ?
asked by: Fred J
0
Expert Reply:
The Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter part # TRSS350 is designed for a 3-1/2" diameter axle so the opening of the cutout/arch is 3-1/2" which you can see in the photo below.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 3-1/2 Inch
- TruRyde
more information >
Continue Researching
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Article: Best Camper Jacks
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Article: Trailer Wiring Diagrams
- Q&A: How To Lift Trailer with 3-1/2 Diameter 8k Axle With Center Point Suspension Already Installed
- Q&A: Availability of 3-1/2 Diameter Axle U-Bolt
- Q&A: How to Raise a Trailer for More Ground Clearance
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Trailer Tire Sizing
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers