Troubleshooting Running Lights Not Working On 2019 Nissan Frontier With Hopkins Wiring Harness
Question:
Hello, I bought the hopkins plug and play wiring harness but I have no running lights going to trailer just brake and turn signals. I used a probe light when the lights are and I got no power from both the 4 way and 7 way. Please help.
asked by: Brian A
Expert Reply:
There isn't much to the # HM43534 so I would check out the vehicle wiring. You could start by checking the Hopkins wiring right after the vehicle connector, or test the connector and wire on the vehicle side. More than likely you don't have any power coming from the factory wiring. Assuming that is the case, I would check the fuses. If a fuse isn't blown then it is likely a short in the wiring which you can attempt to find and repair or take it to a local repair shop.
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Flat Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Determining Replacement Hub And Bearings For Dexter P-12 SLR Trailer Axle
- Q&A: Replacement Parts for Lippert Coach Step on Class A Motorhome
- Q&A: Will the Dexter E-Z Flex Suspension Kit Work With 3,500 Lb Axles
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Best Track System for a Roof Rack on a NuCamp T@G Camper
- Q&A: Lowering Height at Front of Fifth Wheel Trailer By Adjusting Pin Box
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: Replacement Double Lip Grease Seals for Boat Trailer Grease Seal # 171255UC
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Which Hitches are Made in the USA
- Article: Brake Controller Installation: Starting from Scratch