What Tools are Needed for Installing Curt Hitch C12264
Question:
HI, Ahead of actual installation Ive been trying to ascertain what the socket size would be for the three through hitch to frame mounting bolts. So far Ive been told 10 and 12 mm but I dont believe that is correct, other than perhaps for the muffler hanger mounting bolts on the passenger side of the van. I believe these bolts may be 15mm and 18mm but would like to be certain. With the bolt closest to the rear bumper being #1 middle bolt #2 and front most bolt #3 what is the socket size for these bolts?
asked by: Dave
Expert Reply:
To install the Curt hitch part # C12264 that you referenced Curt states you will need the following tools:
3/8 inch ratchet
18 mm socket
15 mm socket
13 mm socket
torque wrench
screw driver/punch
utility knife
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Trailer Wiring for a 2015 Dodge Grand Caravan
- Q&A: Is Transmission Cooler Needed When Towing With 2015 Dodge Grand Caravan?
- Q&A: Curt Class II Hitch and Trailer Wiring that Fit 2012 Chrysler Town and Country
- Q&A: Replacement Oil Cap for Dexter Hub # 21-35
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What To Do When You Break A Bolt Off In A Weld Nut When Installing A Trailer Hitch
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will an ST205/75-15 Trailer Tire Fit In Place of a 205/70-15 Tire
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Which Hitches are Made in the USA
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: 5 Things to Know About Weight Distribution Hitches