Trailer Hitch For A 2002 Dodge Ram 1500 Pickup
Question:
Is there a video on hoe to install this hitch on a 2002 dodge ram 1500?
asked by: Fernando
Expert Reply:
There is currently not an installation video on the installation of The Curt Trailer Hitch Receiver # C13320 it does come with detailed instructions and is not a hard install.
The hitch is confirmed to fit your 2002 Dodge Ram 1500. It has a bolt-on installation with no welding required. It has a gloss black powder coated finish which is over a protective base coat that offers superior rust resistance.
The trailer hitch has a maximum gross trailer weight up to 6,000 pounds and has a maximum tongue weight up to 600 pounds. I would recommend checking your vehicle's manual to find the proper towing capacity for your vehicle.
The Curt T-Connector Vehicle Wiring Harness # C55504 gives you a 4-flat connector and makes it to where your trailer's stop, turn, and taillights mirror your vehicle's stop, turn, and taillights. This harness plugs into your vehicle's wiring harness, which is located behind the rear bumper on both the driver's and passenger's sides.
The Curt Towing Starter Kit for 2 inch Hitches # C45554 includes an 8-1/4 inch long, powder coated ball mount with a pre-torqued hitch ball; hitch pin and clip; hitch receiver lock with keys; hitch cover; and a storage case.
I attached a review video link below.
Products Referenced in This Question
Curt Towing Starter Kit for 2" Hitches - 2" Ball - 2" Rise, 4" Drop - 7.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 2 Inch Ball
- One Ball
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 4 Inch
- Rise - 2 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Ball Mount Kit
- CURT
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Wiring Diagram for a 7-Way Trailer Connector Vehicle End on 2002 Dodge Dakota
- Q&A: Trailer Hitch Fit for 2003 Dodge Ram 1500
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Best Bike Racks for Electric Bikes
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: How Far will Erickson Big Bed Load Extender # EM07600 Extend Past Hitch on Toyota Tacoma 5 FT Bed
- Q&A: Wet Suspension Bolt vs a Regular Suspension Bolt
- Q&A: Brake Controller Install Harness for 2013 Winnebago on Ford F-53 Chassis
- Q&A: Hitch Recommendation for a 2003 Dodge Ram 1500 Without Factory Hitch