Mounting Bolt Pattern for 12K Superwinch SX12SR Integrated Off-Road Winch
Question:
What is the bolt pattern for this winch?
asked by: Conrad
0
Expert Reply:
The Superwinch SX12SR Integrated Off-Road Winch # SW49GR uses the standard 10" x 4-1/2" bolt mounting pattern.
I've attached a photo showing these dimensions as well as a review video for you to check out.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Superwinch SX12SR Integrated Off-Road Winch - Synthetic Rope - 12,000 lbs
- Electric Winch
- Jeep Winch
- Truck Winch
- Recovery Winch
- 3-Stage Planetary Gear
- 6.0 HP
- 10001 - 12000 lbs
- Slow - 0 to 4 fpm
- Plug-In Remote
- Synthetic Rope
- Superwinch
more information >
Continue Researching
- Q&A: Can Draw Tite Front Hitch # 65063 Fit 2018 Ram 2500 without Tow Hooks
- Q&A: How To Choose Correct Size Wire for 12K Winch on Rear of Vehicle
- Q&A: Winch Mounting Plate for 2 Hitch Receiver to Fit Warn M12000 Winch
- Q&A: Differences Between Curt C31017 and Draw-Tite 65046 on 2007 Dodge Ram Truck
- Q&A: What Is The Thread Size For The Zerk Fitting On The Morryde Wet Bolts MR52HR
- Q&A: Total Drop of Curt Front Mounted Receiver # C31017
- Q&A: Front Mounted Trailer Hitch Receiver Fit on 2006 Dodge Ram 1500
- Article: How to Choose the Right Trailer Hitch Class
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Rent an RV