How to Wire Three Power Sources to Two Transfer Switches
Question:
how can i run this transfer switch to go between a onboard generator shorepower and a 4000 w inverter
asked by: Vincnt
Helpful Expert Reply:
I do have an option for you but none of our power transfer switches will allow you to switch between three AC power sources. However, I do have a way for you to do this but you will need to install two power transfer switches like the Go Power Automatic Transfer Switch part # 34264403 for example. A transfer switch will have a single dominate side. So how the input is wired into the switch will affect how it passes power through, so two switches could be wired using the attached photo
Product Page this Question was Asked From
Go Power Automatic Transfer Switch - Plastic Case - 30 Amp - 120V
- RV Transfer Switch
- 30 Amp
- 120V
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can Go Power Transfer Switch Work With 2,000 Watt Inverter
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Direct Replacement Converter for Parallax/Magnetek 6345 RV Power Converter
- Q&A: Can Go Power Solar Flex Eclipse be Easily Added to Go Power Setup on RV
- Q&A: Recommended Power Transfer Switch for Three AC Power Sources
- Q&A: How to Hook a Cargo Trailer Up to Shore Power
- Q&A: Does Go Power Automatic Transfer Switch # 342GPTS Have Internal Fuse and Wire Gauge to Use
- Q&A: Troubleshooting A Furrion Tankless Water Heater That Does Not Hold Temperature
- Article: Trailer Wiring Diagrams
- Article: Measuring a Trailer Tire
- Article: Stability Control for Heavy Duty Vehicles
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?