Can You Spin the Axle When Installing Dexter Trailer Springs Over-Under Conversion Kit
Question:
I want to take an existing axle on a 4x6 carry in trailer and set the axle under the leaf springs to give it a lift. I understand that the bend camber should be facing up. Can I spin the axle 180 so that the right tire hub will be in the left tire hub without compromising the axles ability to function?
asked by: Eugene
Expert Reply:
The correct way to raise a trailer by swapping the axle location i.e. under the spring versus over would be with an over under kit like the Dexter Trailer Springs Over-Under Conversion Kit part # K71-385-00 for 2-3/8" diameter axles or part # K71-385-00 for 3" diameter axles. The axle bend would remain in the same orientation. I am not sure why you'd spin the axle but this is not needed nor recommended.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler