How To Determine The Correct Replacement Light Lens For Westin Molded Step Boards

Question

Question:

My running boards have a ovel gasket do you have a replacement? 3 1/2 inch light

asked by: Larry B

0

Expert Reply:

Its hard to say for sure what will and will not work for you due to not knowing what running boards you have, however the :

-Replacement Lenses and Housings for Westin Molded, Lighted Running Boards # 27-9904 does sounds like what you're looking for.

These lenses are 3-5/8" from side edge to edge, 1-3/8" from top edge to bottom edge, and is 1-1/8" thick.

Since these lights are so close to what you're needing, these are likely what you're needing, however to be completely sure I would need to know what your current running boards are.

If you let me know what you have, I'd be happy to cross-reference and verify if these will work for you or not.

expert reply by: Bryce D

0

Westin LED Light Lens Dimensions
(click to enlarge)

Answer 1

Like the Custer Rubber Grommet #G65G, all the oval grommets we currently carry will be designed to fit a 6-1/2" light, like the Optronics LED Trailer Tail Light #STL72RB. However, we do have the Replacement Lenses and Housings #27-9904,…

view full answer...

Answer 2

If you have the Westin Molded, Lighted Running Boards #27-0025-1215 on your 2005 Ford F-350 King Ranch you will need Replacement Lenses And Housings #27-9904, and the Replacement Light Housings #27-9902. If you have different running boards on your…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…

view full answer...

How To Determine The Correct Replacement Light Lens For Westin Molded Step Boards

Product Page this Question was Asked From

Continue Researching