Replacement Bolt-On Swivel Jack for Boat Trailer
Question:
I need advice on choosing a trailer jack for my boat trailer, its a very light boat but I do want a swivel wheel that doesnt seize up. The current jack puts the trailer about 19 inches above the ground and is maybe a little over 2 feet with everything retracted. It is held on by a flat plate up against the side of the tongue with two nuts and bolts on the top and two nuts and bolts on the bottom. The tongue is 3 x 3 It is the kind that you can pull a D shaped handle and then you can turn the jack to be parallel to the ground and it locks in place. Thanks
asked by: Jt N
Helpful Expert Reply:
For a replacement for your boat trailer jack I recommend the Fulton Round, Snap-Ring Swivel Marine Jack # FTJ12000101. This jack has a bracket height of 13" when retracted and 23" when extended for a total lift of 10". The overall height of the jack will be at 2' just like your existing jack.
This features a bolt on installation and a pull pin which will allow it to swivel and sit parallel to the frame for storage while towing. The jack also fits up to a 3" x 5" trailer tongue so you won't have any issues mounting it. It has a Z-Max 600 finish for a 600-hour salt spray rating and comes with a limited 3-year warranty.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub with LM67048 Inner Bearing and LM11949 Outer Bearing
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can 17-RPM Lift Motor for Fan-Tastic Vent B Series Be Used Instead of 7-RPM Lift Motor
- Q&A: Will the CE Smith Roller-Style Guide-Ons Fit an EZ Loader Boat Trailer with 4 Inch Tall Frame
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Q&A: Replacement Hub for DICO 45264
- Q&A: What is the Angle of the CE Smith Roller-Style Guide-Ons for Boat Trailers
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)