Where to Ground Docking Lights On a Jon Boat
Question:
When insralling these lights on a jon boat, where do the ground wires go? T ok the negative battery terminal? The hull? There are 2 wires that are instructions say to ground. Thanks
asked by: Jack
Expert Reply:
On a boat you would want to ground docking lights # DL-16CC to the negative battery terminal. You will want the connections to be water tight as best as you can. Shrink tubing, electrical tape, and even liquid electrical tape # SWC50122 will help protect electrical connections from water. You can also use dielectric grease, # 11755, between electrical connections. This special grease is hydrophobic so it will repel moisture.
Products Referenced in This Question
Dielectric Grease for Electrical Connectors, 2 oz.
- Accessories and Parts
- Trailer Wiring
- Wiring
- Dielectric Grease
- LubriMatic
more information >
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Work Flood Light Fitment for 3-1/2" Wide x 2-1/4" High Spacing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Check Valve Replacement for Lippert Hydraulic Slide Out
- Q&A: Interior and Exterior Horse Trailer Light Recommendations
- Q&A: LED Flood Light Recommendation for the Sides of a Horse Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions of Lens for Optronics Halogen Utility Light
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommendations for Spare Wheel on 1965 Lil Loafer Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)