Recommended Replacement 5,200 Pound Axle for Extreme Boat Trailer
Question:
I have a single axle boat trailer with tortion bar suspension made by Extreme. The tortion bar suspension spun so I believe I need to replace the axle. The Hub Face is 93 and 74 outside bracket. Its a 4 plus tube size? I was told to look for Dexter and that it was originally UFP. I need 5200 lb capacity. The axle has a dip in the middle to make room for the boat. Can you recommend / provide a part.
asked by: Bruce P
Helpful Expert Reply:
While we may have an option for you, if you are strictly looking for a 5200 pound axel that has a dip in the middle, we do not carry any axle beams that have that specific dip you need. With that being said, a great option is the Timbren Axle-Less Trailer Suspension System # TASR5200S05. Since the axle-less system comes does not come with a crosstube, you do not need to worry about the axle interfering with the trailer/boat. As far as installation, the Timbrens can be bolted or welded directly onto your trailer's frame. It also provides you with a superior ride than a traditional axle bar because the left and right side react independently to changes/bumps in the terrain.
If you need the hub/drum assemblies as well, those are the # 8-201-9UC3-EZ.
I went ahead and attached some helpful demo videos of these products for your convenience.
![Bob C](https://images.etrailer.com/static/images/catg/people/2465_tn.jpg)
Products Referenced in This Question
Dexter Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb Axles - 6 on 5-1/2 - Pre Greased
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Pre-Greased
- 25580
- 15123
- For 5200 lbs Axles
- For 6000 lbs Axles
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- Dexter
more information >
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Standard Duty - 2" Lift - 5 Bolt Flange - 5,200 lbs
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- 5200 lbs
- Spindles Only
- Universal Fit
- Lift - 2 Inch
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Enjoy The 2024 Eclipse With Harvest Hosts
- Q&A: Replacement Al Ko 10k Brake Calipers and Brake Pad Recommendation
- Q&A: How to Make Fulton A60 Swinging Coupler Compatible with Disc Brakes
- Q&A: Recommended 5200-6000lb Axle For M105 Military Trailer Being Converted To Overland Trailer
- Q&A: Can 10" Brake Assemblies Be Swapped Out With 12" Brake Assemblies
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: Can 235/75-15 Trailer Tires Be Replaced With 235/85R16 Tires For Higher Load Capacity
- Q&A: Brake and Hub Parts Needed for 4 Lift Timbren Heavy-Duty Axle-Less Trailer Suspension
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Calculating Portable Generator Power Needs
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision