Is the Replacement Plug and Strap for Valterra RV City Water Inlet Garden Hose Thread

Question

Question:

Re: Replacement Plug and Strap for Valterra RV City Water Inlet - 3/4 Male Thread Item # T1020-1EVP Q: is this garden hose thread? That’s what I need to keep garden sprinklers clean during off season.

asked by: Diane K

1

Helpful Expert Reply:

I contacted the manufacturer and they were able to confirm that the Replacement Plug and Strap for Valterra RV City Water Inlet # T1020-1EVP does have 3/4" garden hose threads on it.

expert reply by: Scott S

1

Answer 1

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 2

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 3

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 4

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

view full answer...

Answer 5

Yes, the Pro Series replacement 20k fifth wheel hitch head part #30118 will fit as a replacement for the head of the Pro Series 16k hitch you have installed currently.

view full answer...

Answer 6

Thanks for sending a picture! It really helps! Yes, you can upgrade your head assembly on your Reese 16K slider hitch. I recommend the Reese replacement double pivot 20K head and head support #30118 as it will work with your current Reese Kwik-Slide.…

view full answer...

Answer 7

Yes the Pro Series hitch head part #30118 would fit the same leg kit as your 15k Reese fifth wheel hitch.

view full answer...

Answer 8

The Reese 16K and available 20K hitch heads do not fit in the same center sections so you cannot replace the head with any of the 20K Reese heads. The Pro Series head and center section #30118 will work since the bolt holes you have now are 1/2…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

The Timbren Active Off-Road Bumpstops part #TABSTORSEQ which are a fit for a 2023 Toyota 4Runner are pretty similar to the SumoSprings Solo Custom Helper Springs like part #SS68DR. The Timbrens provide more support but the SumoSprings ride smoother.…

view full answer...

Answer 11

With an unloaded ride on your 2006 Toyota Sequoia, there will be approximately 1 inch of space between the axle and the bottom of the SumoSprings Solo Custom Helper Springs #SS68DR. These are a light capacity helper spring, and if you are off-road…

view full answer...

Is the Replacement Plug and Strap for Valterra RV City Water Inlet Garden Hose Thread

Product Page this Question was Asked From

Continue Researching