Hidden Trailer Hitch that Fits 2023 Audi S5

Question

Question:

Do you guys have a hidden hitch that fits my 2023 Audi S5? It's for my bike rack.

asked by: Reno H

0

Expert Reply:

Yes we do. For your 2023 Audi S5 we do have hidden hitches that are a fit from Stealth. For that you would want the part # 391AUDA5S518. Or if you planned on ever doing some towing you'd want the # 391AUDA5S518T which comes with a ball mount attachment and trailer wiring.

expert reply by: Jameson C

0

Answer 1

Yes, you will need to trim a small section of your rear fascia on your 2023 Audi S5 to use the Stealth Hitches Hidden Rack Receiver #391AUDA5S518. I have included an image below showing the area needed trimmed on your 2023 as it is different than…

view full answer...

Answer 2

Yes, we currently have two options from Stealth Hitch to choose from depending on your needs. If you're only planning on hauling around a bike rack or cargo carrier then the Stealth Hitches Hidden Rack Receiver #391AUDA5S518 is the right option…

view full answer...

Answer 3

For your 2021 Audi Q5 convertible I recommend the Stealth Hitches Hidden Rack Receiver item #391AUDA5S518. This is a custom fit 2" receiver that requires no drilling to attach to your vehicle. It has a maximum tongue weight of 350 lbs and has a…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Hidden Trailer Hitch that Fits 2023 Audi S5

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching