Recommended Replacement Exterior RV Ladder For At Least 9 Feet Height

Question

Question:

i need a rv ladder measured from top to bottom is 9ft can you direct me to the proper ladder chrome. i think youll have to do a 8ft with extender? ill need that if it will get me to 9ft i need to try to match up where the old ladder is.

asked by: Pete

0

Expert Reply:

I have a great recommendation for you. I recommend the Stromberg Carlson RV Exterior Ladder w/ Hinges, # LA-401 that is 99-1/2" and the add the Stromberg Carlson RV Ladder Extension, # LA-148.

The Stromberg Carlson's universal RV ladder can be attached to an RV with either a contoured or straight rear wall and the legs of the ladder can be trimmed for length with a hacksaw or tube cutter. Then add the Stromberg Carlson RV Ladder Extension, # LA-148 when needed that provides an extra 48" of length. But best of all, this will extend to the ground for a solid and easy start up the ladder.

expert reply by: Michael R

0

Answer 1

We do carry replacements for the Carefree brand. From what I have found, yours has 67" long arms on your 2017 Coleman 3015bh. The ones we offer are designed by Solera and are universal. They match the design of your current arms however; are…

view full answer...

Answer 2

We do offer a range of RV exterior ladders that are general-purpose replacements that will work on many trailers and RVs, but none of these is a custom-fit item intended as an exact OEM replacement for any particular unit. RV makers may change ladder…

view full answer...

Answer 3

We do have replacement support pegs available for RV exterior ladders, which I have linked for you to look through. In order to choose a compatible replacement, you will want to measure the length of your existing units. For 5 inch support pegs, we…

view full answer...

Answer 4

Each of the motors of the Happijac Electric Truck Camper Jack System #LC736515-ELKIT is protected with a 25 amp fuse. So it can pull right up to 25 amps.

view full answer...

Answer 5

If your original ladder was 84-1/4 inches long, the Surco Universal Exterior RV Ladder #SP502L would work well for you. I don't have access to any reference material that would tell me which ladder would have originally been used on your 1999…

view full answer...

Answer 6

We do not recommend to modify the Surco Universal Exterior RV Ladder #SP502L to fit your camper as it may compromise the structural integrity of the ladder. However, if you choose too, you should be aware that the steps are welded to the frame of the…

view full answer...

Answer 7

Yes. You can replace the Progressive Dynamics PD4590K18NS2 with the Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp #PD4590CSV without any issues. Both are 90 amp converters from the same Series and…

view full answer...

Answer 8

I spoke to Progressive Dynamics, the Progressive Dynamics REL 90A 4500 Series Inteli-Power Converter Section part #PD4590CSV is a fit for you 4590 panel. You have an older style panel which uses a different fan layout but the above will fit and is…

view full answer...

Answer 9

For an RV ladder that has a hinge half way up the ladder we have the Stromberg Carlson #LA-401 which would work well for you. The hinge allows the lower portion to fold like you are wanting so that it can match an angled RV wall like in the picture I…

view full answer...

Answer 10

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Recommended Replacement Exterior RV Ladder For At Least 9 Feet Height

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching