Replacement Remote Cable And Remote For The Happijac Electric Camper Truck Camper Jack System

Question

Question:

I want to replace the wire on the remote of my happy jack where can i find it

asked by: Sylvai

1

Helpful Expert Reply:

It sounds like you're looking for the Replacement Remote Cable for HappiJac Electric Truck Camper Jack Systems # LC149557, and will work with the Replacement Remote Control for HappiJac Electric Camper Jack Systems # LC723915.

expert reply by: Bryce D

1

Answer 1

Since the motors work when connected directly to power and you are getting the green light on the remote, it sounds like everything is operational. The remote with the Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper…

view full answer...

Answer 2

I checked with Happijac and the correct replacement remote you need for your Happijac system that has 4500s and 4150s is the part #LC723915 that you referenced.

view full answer...

Answer 3

The Replacement Remote #LC723915 will work as a wireless replacement remote for camper jack systems LC736514-ELKIT and LC736515-ELKIT. If you have a different model of jack system, let me know and I can check to see if there is a replacement…

view full answer...

Answer 4

For 7-way wiring typically the red wire is for the left turn/stop signal, the black wire is the 12 volt power accessory circuit, the blue is for brake controller output, and the green is for running lights.

view full answer...

Answer 5

The Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper Jack Systems #LC733540 is only compatible with HappiJac electric camper jack systems like the HappiJac Electric Truck Camper Jack System #LC736514-ELKIT, and is not…

view full answer...

Answer 6

The Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper Jack Systems #LC733540 does come with the new circuit board and the remote but not the harness #LC149557.

view full answer...

Answer 7

There are fuses on your circuit board for your HappiJac system. I recommend locating the circuit board and checking the fuses first. According to Lippert, if the fuses are not the problem you have a bad circuit board and will need to replace it with…

view full answer...

Answer 8

The Replacement Remote Cable for HappiJac Electric Truck Camper Jack Systems #LC149557 is just the way for your remote #LC723915 to connect to the controller for initial setup or if you had an older non-wireless model. It won't control anything…

view full answer...

Answer 9

The Replacement Remote Control for HappiJac #LC723915 is the replacement remote compatible with the Replacement Circuit Board for HappiJac #LC733513. HappiJac has two remotes, one is compatible with the older circuit boards that have a 20 amp fuse.…

view full answer...

Answer 10

As long as the motorcycle and carrier do not exceed the vertical load rating of the Curt Front Mount Trailer Hitch Receiver part #C31015 which is 500 lbs then you will be able use this hitch. Please keep in mind that you will also want to check in…

view full answer...

Answer 11

Yes, you can utilize a phone-style cord like part #LC149557 with that plug on the side of the Replacement Remote Control for HappiJac Electric Camper Jack Systems #LC723915 to operate your jacks. Lippert calls this out in their troubleshooting table…

view full answer...

Answer 12

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Replacement Remote Cable And Remote For The Happijac Electric Camper Truck Camper Jack System

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching