How Does Reverse Lock Out Solenoid of Titan Surge Actuator Get Wired
Question:
I have just purchased this item and have a few questions. Should it come with instructions? Past Titan actuator I had came with instructions. There were no instructions in the box. I am looking for any wiring instructions for the electronic lockout. Also the past actuator I had, you can place a lock on it to prevent the trailer from being detached. Is there a suggested way to do this with this actuator? Thanks.
asked by: Kelly I
Expert Reply:
The Titan Actuator part # T47457207K should have came with instructions but sometimes like anything they get misplaced before shipping. With the reverse lock out solenoid basically one of the wires runs to the reverse light circuit of the vehicle and the other gets grounded. The wires aren't polarity sensitive so either could be used as the power and ground wire.
There isn't a coupler lock available for this coupler due to it being the multi-ball setup that fits more than one ball size. That's the trade off with this style of coupler.
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator w/ Electric Lockout - Disc - Multi-Fit Ball - Bolt On - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7000 lbs GTW
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Continue Researching
- Shop: Dexter Zinc-Plated Brake Actuator - Disc - Multi-Fit Ball - Bolt On - 7,000 lbs
- Shop: Dexter Zinc-Plated Brake Actuator w/ Electric Lockout - Disc - Multi-Fit Ball - Bolt On - 7,000 lbs
- Shop: Demco Hydraulic Brake Actuator w/ Electric Lockout - Disc - Zinc - 2" Ball - 7,000 lbs
- Shop: Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 10" - Left/Right Hand - 3,500 lbs
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Video: Demco Electric Lockout Hydraulic Brake Actuator Installation
- Shop: Dexter Premier Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Search Results: 7 pin trailer wiring harness
- Q&A: How To Find Correct Replacement Disc Brakes, Rotors, Hubs, and Bearings for a Boat Trailer
- Q&A: Can 7k Titan Disc Brake Actuator be Used with 6k Trailer Disc Brakes
- Q&A: Surge Brake Actuator Recommendation for a Boat and Trailer that Weigh 2,200 lbs
- Q&A: Can You Reverse With Brake Actuator T47457207K And The Brakes Not Lockup
- Q&A: Troubleshooting Trailer Disc Brakes that Won't Activate Although Actuator Moves Fluid
- Video: Review of Demco Brake Actuator - Surge Brake Actuator - DM72VR
- Video: Titan Brake Actuator - Surge Brake Actuator - T43397007K Review
- Q&A: Will Demco Hydraulic Brake Kit Fit 13" Wheels
- Q&A: Replacement Hub/Drum and Hydraulic Brake Assembly for Boat Trailer With 3,500 lb Axle and 13" Wheels
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Video: Review of Titan Brake Actuator - T4820000
- Video: Review of Dexter Brake Actuator - Replacement Master Cylinder with Solenoid - DX44FR
- Video: Review of Dexter Axle Brake Actuator - 099-175-20
- Video: Demco Hydraulic Brake Actuator Reverse Lockout Solenoid Kit Installation
- Search Results: 8~247~50uc3~ez
- Search Results: 40716~15
- Search Results: hydraulic drum brakes
- Search Results: brake actuator
- Search Results: hydraulic brake
- Search Results: dm72vr
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)