Pull Pin Is Frozen On A Fulton F2 Trailer Jack
Question:
I just installed the F2 Jack and both the pull pin are frozen. I cant even move rotate the handle. Obviously I did something incorrect but before I unbolt again and reinstall, checking if maybe I over torqued a bolt or something that would cause this. I did loosen the height adjustments bolts and retighten them, could that be the problem?
asked by: Casey C
Expert Reply:
I spoke with Fulton, and they believe the issue with your Fulton F2 Swing-Up Trailer Jack is that there is dirt, grime or corrosion in the pull pin mechanism, and that is affecting its operation.
I recommend using some penetrating lubricant, or some WD-40 to spray the area to free it.
Product Page this Question was Asked From
Replacement Pull Pin Kit for Fulton F2 Swing-Up Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement Parts for Fulton F2 Dual Wheel Trailer Jack
- Q&A: Do Instructions Come with Fulton Replacement Pull Pin Kit for Fulton F2 Jack Part # F500136
- Q&A: How To Determine Weight Capacity Of Torsion Axles
- Q&A: What Brake Fluid Should Be Used With Titan BrakeRite EHB Actuator For Disc Brakes
- Q&A: Replacement Pull Pin Kit For Fulton Trailer Jack
- Q&A: Plunger Pin Replacement for a Shelby Model 5856A Trailer Jack
- Q&A: Replacement Jack handle for Fulton F2 Series Sing-Up Trailer Jacks