Why Is The Bend On My Jet Ski Trailer Axle Pointed Down Rather Than Up?
Question:
I noticed yesterday that the axle on my double place trailer for my jetskis, that the bend is facing downward, tires are wearing normal and even, but I’m concerned this is wrong and need to replace my axle.
asked by: Joe M
Expert Reply:
It sounds like either the person who assembled the trailer or a previous owner may have place the axle under the leaf springs rather than on top of the leaf springs rather than using the correct Over-Under Conversion Kit # K71-384-00. This is often done by those who are wanting more ground clearance and do not understand the axle design. If you do not see any damage to the axle you can have the conversion kit installed to place the bend going up.
If you would rather have the axle replaced I can help you find the correct replacement if you can send me the axle tag information or the hub face and spring center separation from left to right along with the required weight capacity and orientation you need.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Breaking In Replacement 6,000 lbs Leaf Springs
- Q&A: Recommended Lift Kit for 2021 Forest River Gray Wolf Travel Trailer
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Trailer Wiring Diagrams
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: How to Increase Trailer Ground Clearance Using an Axle Over-Under Kit
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current