Correct Roller Bunk Bracket for Mounting Roller Bunks on Tracker Trailstar Trailer
Question:
The trailer I want to install roller bunks is a Tracker Trailstar for a 17’5” bass tracker boat. It has 3 brackets that are welded to the frame to hold the 8’ wood-carpet bunks. I’m thinking I would want to replace those with 2 4ft bunks on each side. I’m concerned about the mounting bracket in the center. The welded brackets rise 3” above the trailer frame. I’m hoping to use part DL21742 for an attachment point in the center, between the 2 - 4’ roller bunks. My concern is I can’t tell from the dimensions listed what the minimum rise is of the bracket. My thought is to drill a hole thru the welded bracket on the trailer, and use DL21742 with a u-bolt for the other side. Will this part work? Or is there a better solution I haven’t considered? Thanks!
asked by: Wade M
Helpful Expert Reply:
Based on what you are describing the Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks Parts # DL21742 will likely work. From the top of the mounting slot to the top of the bracket is approximately 2-3/4" so you should be able to get it at the 3" height you're looking for.
The only potential problem is that this may vary depending on the mounting hardware used since the mounting hardware may be in contact with the swivel at varying heights depending on the size of washers/nuts/bolt heads. For mounting with U-bolts I recommend the # CE15283GA.
The only better solution I have is to replace all of your brackets with the # DL21742 which will ensure everything is at the same height and prevent you from having any potential issues. If your existing brackets are older this would be a good idea regardless.
Products Referenced in This Question
CE Smith U-Bolt - Galvanized - 3-13/16" Long x 3-1/16" Wide x 1/2" Diameter - Qty 1
- Boat Trailer Parts
- U-Bolts
- 3-1/16 Inch Wide
- 1/2 Inch Diameter
- Galvanized Steel
- 3-13/16 Inch Long
- CE Smith
more information >
Product Page this Question was Asked From
Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks Parts DL21740 & DL21741
- Boat Trailer Parts
- Bunks
- Rollers
- Roller Bunk Bracket
- Zinc-Plated Steel
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Size of U-Bolt Slots in Dutton-Lainson # DL21742 Roller Bunk Bracket for Roller Bunks DL21740/41
- Q&A: What Size Bolts to Use to Install Dutton Lainson Roller Bunks
- Q&A: Can I Convert Regular Bunks To Roller Bunks
- Q&A: Do Roller Bunk Brackets DL21742 Require 7/16" U-Bolts?
- Q&A: Recommended Roller Bunks For Tracker Deep V Boat
- Q&A: How to Attach Roller Bunks # DL21741 to 6 Ft Wooden Bunks on a Boat Trailer
- Q&A: How to Covert my Roller Bunks to Wooden Bunks on my Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Best Tire Chains
- Article: Boat Trailer Showdown: Bunks vs. Rollers
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Determining Trailer Tongue Weight
- Article: Troubleshooting 4 and 5-Way Wiring Installations