How to Add Clearance Between 6,000 lb Axle And Trailer Frame
Question:
Hello Sir, Trailer pipe line is passing below the frame. So there is very less gap between axle and pipe line 10-20mm. The spring is place underslung setup with tandem axle. Axles are 6000 lbs each. Is there any way to increase axle clearance ? Can we place 10 to 20mm space between axle and U bolt at top? or can we place the the spring as over slung setup?
asked by: Janesh
Expert Reply:
You can indeed add clearance between the axle tube and trailer frame, and the best option to do so for your 6,000 lb axle is with an over-under conversion kit. This will turn your underslung set up into an overslung just like you mentioned; the correct part for your 6k axle is the following:
- Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00
The # K71-385-00 will move your trailer's leaf springs to the top of your axle and lift your trailer approximately the same amount as your axle's diameter plus the height of the leaf spring pack.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler