Recommended Replacement A-Frame Jack For A 2021 Aliner Ranger 12
Question:
Hi - Just bought a Aliner Ranger 12 A-Frame Campler ~1600lbs and promptly bent the trailer jack. It was a RAM 2000 series 3,000 maximum. Im pretty much looking for an exact fit replacement as I do have a wheel and I believe the screw holes in the trailer tongue are 3inch on center so I dont want to do any additional drilling or mods. I saw your Pro Series Round, A-Frame Jack w/ External Gearbox - Sidewind - 14inch Lift - 2,000 lbs Item # PSRV20000103. Is this a good replacement? Suggestions? Thanks!!
asked by: Mark S
Expert Reply:
The Pro Series Round, A-Frame Jack # PSRV20000103 will definitely definitely fit in frame as the 3" triangular bolt pattern is a standard, but I cannot 100% say that your existing wheel will fit. It most likely will, but I do have an option that I can 100% say will work.
The etrailer.com Round A-Frame Trailer Jack # TJA-5000T-B is a RAM jack, though this will be a little more heavy duty than your original one. It will have a 5,000 pound support capacity, a 3,000 pound lifting limit, and 15" of lift, but will still fit that 3" triangular bolt pattern. This is the one I would go with.
Products Referenced in This Question
Round A-Frame Trailer Jack - Topwind - 15" Travel - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 3001 - 4000 lbs
- Topwind Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack w/ External Gearbox - Sidewind - 14" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Continue Researching
- Q&A: Replacing Atwood Mobile Products model MPD 80274 Recommendation
- Q&A: Parts Needed to Connect Ozark Camping Stove W/ Disposable Cylinder to Regulator
- Q&A: Measurement From Outer Tube Of Pro Series 2,000 Lb Trailer Jack To End Of Handle
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: Trailer Wiring Diagrams
- Q&A: Will Jack-It 2 Bike Rack for A-Frame Trailers Work with Topwind Jack
- Q&A: Drag Roller Recommendation for Boat Trailer with Prop Protector Cut Out
- Q&A: Number Of Rotations For # PSRV20000103 To Fully Travel The 14 Inches
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Bike Racks for Electric Bikes