What is Purpose of Bumps On Mounting Flange of Erickson E-Track Tie-Down Anchor # EM37JR
Question:
Are the 4 bumps around the periphery tie down points or just areas to get a screwdriver under for prying up if the tie down gets stuck to the floor?
asked by: Andrew W
0
Expert Reply:
The bumps around the edge of the Erickson E-Track Tie-Down Anchor # EM37JR are there to add strength to the flange so that it supports weight better.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Erickson E Track Tie-Down Anchor - 360-Degree Swivel - 2,000 lbs
- E-Track
- E-Track Anchor
- 2000 lbs
- Erickson
more information >
Continue Researching
- Q&A: Can Holes be Drilled to Add A-Frame Jack to Trailer
- Article: Determining Trailer Tongue Weight
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions Of Erickson E-Track Tie-Down Anchor # EM37JR
- Q&A: Recommended Trailer Tie Down System For Hauling Vehicles In an Enclosed Trailer
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Tie-Down Recommendation for Bulldog Winch Ratcheting Wheel Tie-Down Strap
- Q&A: Backing Plates And Wheel Straps For Securing Vehicles In Enclosed Trailer With E-Tracks
- Q&A: Can Storage Boxes be Mounted on Front of V-Nose Trailer
- Q&A: What Screws To Use When Installing E-track To the Side Of Aluminum Trailer Frame
- Article: Cargo Tie-Down Methods
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: What Exactly is Tongue Weight?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft