What Is The Shaft Of The Replacement Crank Handle For Etrailer 5th Wheel Landing Gear RVLG-HDL
Question:
What Is The Shaft diameter Of The Replacement Crank Handle For Etrailer 5th Wheel Landing Gear? Is it 1/2inch or 5/8. I previously asked this question and the reply was about the slotted end. I do not care about the dimensions of the slotted end which i plan to discard. I care about the diameter of the saft itself.
asked by: John B
0
Expert Reply:
The diameter of the shaft of the Replacement Crank Handle # RVLG-HDL that you referenced is 1/2 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Continue Researching
- Q&A: Inside Diameter of Replacement Crank Extension for Lippert Spare Tire Winch Assemblies
- Q&A: Lippert Crank Handle for Lippert Spare Tire Winch Assembly
- Q&A: Will The Lippert Spare Tire Winch # LC159056 Fit In Place Of BAL Retract-A-Spare?
- Q&A: Length of Replacement Crank Handle for Ram Scissor Stabilizer Jacks End to Bend and End to End
- Q&A: Long Stabilizer Jack Crank Handle With 3/4 Inch Socket
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Q&A: Replacement Microwave Option for a Greystone Model P10034AP-L3-FR01 Microwave
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: How to Measure for Motorhome Steps
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: Winner International Wheel Locks
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch