Does Curt Weight Distribution Shank C17123 Work with Curt WD System 17022
Question:
Does the Curt replacement hitch shank model #17123 fit the platform head of the Curt model #17022 hitch. In other words are the bolt holes spacing 1 1/4 the same?
asked by: Stuart B
0
Expert Reply:
Yes the Curt weight distribution shank part # C17123 does fit to the Curt weight distribution 17022 that you referenced which is no longer available.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Welded Weight Distribution Shank 7" - 10 Hole Adjustment
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Round - 8 Inch Drop
- Trunnion - 8 Inch Drop
- Round - 12 Inch Rise
- Trunnion - 11 Inch Rise
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can Trailer Weight Capacity Be Increased by Changing One Trailer Axle
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Replacement Drop Shank for the Curt TruTrack Weight Distribution System Part # C17500
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Calculating Portable Generator Power Needs
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: Equal-I-zer Weight Distribution Shank that has More than 3 Inches of Drop
- Q&A: Extending Curt Weight Distribution Hitch to Clear Electric Tongue Jack
- Q&A: Replacement Bearings for Dexter 8-222 Hub
- Q&A: Should Hitch Ball Angle Be Adjusted Up and Down or Angled to the Rear Using Weight Distribution