Installing Trailer Wiring Harness for a 1998 Ford Windstar
Question:
I need an electrical schematic to install the wiring into my 1998 Winstar
asked by: Ron
Expert Reply:
The wiring harness for your 1998 Ford Windstar is a plug and play harness, part # C55346. It plugs into your tail light assemblies. I have also included a link to the instructions for installing it on your vehicle.
The 4 pole round connector you were looking at, part # PK11409, can be used instead of the standard flat connectors. The part you were looking at was the trailer end connector. The vehicle end is part # PK11410. You would cut off the flat connector of the wiring harness mentioned above and wire it into the connector. Once the housing of the connector is apart you will see how to wire it. Just make sure positions of the wires on the vehicle connector match those on the trailer connector.
Products Referenced in This Question
Pollak Heavy-Duty, 4-Pole, Round Pin Socket, Concealed Terminals - Chrome - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 4 Round
- Pollak
more information >
Product Page this Question was Asked From
Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Connector - Chrome - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 4 Round
- Pollak
more information >
Continue Researching
- Shop: Trailer Wiring
- Video: Choosing the Right Trailer Wiring
- Video: Trailer Wiring Harness Installation
- Q&A: 4-Way Flat to 4-Way Round Trailer Plug Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Maintenance Schedule
- Search Results: installation videos
- Q&A: Wiring Diagram Recommendation for 4-Way Round Trailer Connector
- Shop: Trailer Hitch
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Search Results: 44649
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 68149
- Video: Choosing the Right Brake Controller
- Video: Lippert Solera Slider Slide-Topper Review
- Search Results: 25580
- Shop: Grease Seals 10-36 (pair)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Shop: Fifth Wheel Hitch
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Search Results: dust cap
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Shop: Gooseneck Hitch
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
on Trailer Wiring
