How Does Trailer Battery, Breakaway Battery, and Trailer Jack Wire
Question:
Do you have any wiring diagrams with the following. Trailer with power tongue jack, battery, battery powered break away switch, to converter? Thank you in advance.
asked by: Whitney A
Expert Reply:
We do not have any wiring diagrams that have all of the things you mentioned. Basically all of those accessories would need to run to the 12 volt accessory circuit of your trailer wiring so it would be a matter of running that circuit to all of them. The easiest way to do that would be with a junction box like the # HS381-9000 which would give you the ability to run all of the circuits to the same post using ring terminals that are included. You'd then want to run the ground of each accessory either back to the ground terminal of the box or to the trailer frame.
Product Page this Question was Asked From
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Continue Researching
- Q&A: Lance Camper Wiring Harness Recommendation
- Q&A: Is There an Adapter for Lance Truck Bed Camper to Standard 7-Way Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Converting Trailer from Surge Brakes to Electric Brakes
- Q&A: TorkLift SuperHitch Magnum Trailer Hitch Receiver For a 2024 Ram 3500 Pickup
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: When Do Brakes Need to be Added to Both Axles of Tandem Axle Trailer
- Q&A: Converting a Hymer Touring GT Camper from Surge to Electronically Controlled Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Best Vehicles to Flat Tow Behind an RV