Will Hopkins Adapter # 37385 accept two 4-pole flat connectors simultaneously
Question:
I have an LED light bar that has a 4 pole flat connector, and my boat has the same. Can I use the four pole connection for the LED light bar, and then only uses the first four poles on the five pole connection for the boat? This way I can use both simultaneously.
asked by: Bob
Helpful Expert Reply:
Yes, you can use two 4-pole flat connectors into the Hopkins # 37385.
I spoke with my technical contact at Hopkins and he said that many, many people are using this adapter to run two sets of lights simultaneously so you will be fine with this as well.
Even though you can run both at the same time, you also want to make sure you do not overload the circuit of the adapter, however, by running LED lights you will be fine.
Product Page this Question was Asked From
Adapter 7-Pole to 4-Pole and 5-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 7 Round - Blade
- Plug Only
- 4 Flat
- 5 Flat
- Hopkins
more information >
Continue Researching
- Q&A: Trailer Wiring Harness For 2025 Honda Pilot
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Why Does My Brake Controller Light Stay On After Vehicle is Turned Off
- Q&A: Recommended Hitch for a 2024 Mazda CX-90
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: How To Determine Axle Rating Of Dexter Torsion Axles
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Camper Jacks
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Raise Your Travel Trailer Height