Recommended Hardware to Install Plunger and Socket Trailer Door Holder
Question:
What hardware should I use with this?
asked by: Arthur V
0
Expert Reply:
According to the manufacturer you need 1/4 self tapping screws to install part # PLR64-66.
Most likely you'll just find them at your local hardware store. We have part # FA1131822 which are 1-1/4 inches long.
expert reply by:
Charles S
0
Products Referenced in This Question
Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc
- Accessories and Parts
- Trailer Wiring
- Wiring
- Ground Screw
- Flint Hill Goods
more information >
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 2-1/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- 2-1/4 Inch Plunger
- 2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Article: Best RV Roof Vents
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: What is the Best Grease for Trailer Bearings
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: How to Wire a 7-Way Trailer Connector on a 2015 Chevrolet Silverado 1500
- Q&A: How To Attach The Hullavator Pro Kayak Carrier To The Roof Of A 2015 Toyota 4Runner
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Adding 7-Way to Trailer with Yellow Wire Instead of Purple
- Q&A: Color Code for Tow Package Wires on 2002 Chevy Silverado 1500