Can The Command Electronics LED Light 328-ET003184CWM Be Hooked Up To A Dimmer Switch?
Question:
I would like to use these 1inch 3/4inch lens LEDs as ceiling lights in a doll house that is 1/6th scale. Is it dimmable if connected to a dimmer switch, or does it come in a warm white light? Also, it appears that the back end closer to wire unscrews to sandwich the fixture between the surface it is being used on - is that correct? Thank you.
asked by: Elwyn F
Expert Reply:
I spoke to Command Electronics and the LED Bullet Utility Light with Grommet # 328-ET003184CWM can indeed be hooked to a dimmer switch without issue. However, said dimmer switch does need to be rated for use with LED lights as not all of them are
Though the grommet can be removed, the light will not come apart. With the grommet attached, it will snap into a 3/4" hole. A potential add on to go along with this is the Chrome Trim Ring # 328-89-387. It would give them a nice clean look once installed and hooked up.
Products Referenced in This Question
Chrome Trim Ring for Command Electronics LED Bullet Clearance or Side Marker Light
- Accessories and Parts
- Trailer Lights
- Light Trim
- Chrome
- Command Electronics
more information >
Product Page this Question was Asked From
LED Bullet Utility Light with Grommet - Recessed Mount - 1 Diode - Clear Lens
- Work Lights
- Utility Lights
- Interior Lights
- Round
- Recessed Mount
- LED Light
- White
- Command Electronics
more information >
Continue Researching
- Shop: LED Bullet Utility Light with Grommet - Recessed Mount - 1 Diode - Clear Lens
- Shop: Westlake ST205/75R15 Radial Tire w 15" Condor Aluminum Wheel - 5 on 4-1/2 - LR D - Gunmetal
- Shop: Uni-Lite LED Mini Trailer Utility Light w/ Grommet - Submersible - 2 Diodes - Round - Clear Lens
- Shop: Peterson Great White LED Mini Trailer License Plate Light - 1 Diode - Round - Clear Lens
- Search Results: mini led
- Shop: Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: Dexter Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Search Results: 8~247
- Search Results: 023 026 00
- Search Results: 023~026~00
- Search Results: 023~027~00
- Shop: Fulton Fold-Away Coupler Hinge Kit for 3" x 5" Tongue - Bolt On - Up to 9,000 lbs
- Search Results: folding trailer tongue
- Q&A: Should Actual Trailer Weight or Gross Trailer Weight Be Used for Pivot Point on Fulton Fold-Away Kit
- Video: Optronics LED Clearance and Side Marker Light with Grommet Review and Installation
- Search Results: led light
- Video: Kodiak Trailer Brakes 18SI-BLKIT Review
- Video: etrailer Horizontal E-Track Review
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Can Progressive Dynamics Converter PD9260C Charge Lithium Batteries
- Q&A: Does TruXedo Lo Pro Fit 2022 GMC Sierra 3500 Standard Bed With MultiPro Tailgate
- Q&A: Tonneau Cover for 2020 Chevy Silverado 2500 Short Bed Towing Fifth Wheel
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Control Module For The Revolution Kwikee Step 1510000140
- Q&A: Recommended Shade for Gustafson 12V RV LED Ceiling Light
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: Pintle-Hitches
- Article: Best Bike Racks for Electric Bikes
- Article: Where to Position the Trailer Axle?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)