Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted

Question

Question:

In the description, it says suction mount, but the video says you need to buy separate clamp mount.

asked by: Marianne J

0

Expert Reply:

The CIPA Rearview Boat Mirror part # CIP54FR will require the CIPA Mirror Bracket for Boat Windshield part # CM02310 for installation. If you're looking for a suction cup mounted mirror then I recommend the CIPA Rearview Boat Mirror part # CM11050.

expert reply by: Conner L

0

Answer 1

The clamp-on boat rearview mirrors we offer like the #CM11080 you'd looked at will all need a minimum windshield thickness of at least 3/8 of an inch in order to attach securely. If your boat windshield is thinner than that, a suction cup mirror…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Adding a trailer hitch to a vehicle like the 2021 Tesla Model 3 you were looking at at your local Tesla dealer will not void the vehicle warranty. This is due to you being protected by the Federal Magnuson-Moss Warranty Act, passed by Congress in…

view full answer...

Answer 4

You simply measure between the tires about an inch off the ground to determine what Fastway chocks are the best fit for your application. We have the Fastway ONEstep Wheel Chock for Tandem-Axle Trailers and RVs - 16" to 24" Long…

view full answer...

Answer 5

I was able to verify that the weight capacity for the Aluminum Car Hauler Ramp Set #288-07503 that you referenced is indeed 6,000 pounds (not kilograms) for the pair and 3,000 pounds per panel. The recommended maximum height of 16 inches is simply…

view full answer...

Answer 6

The CE Smith Keel Roller for Boat Trailers #CE29505 is our only self centering keel roller. It is 12" wide versus the 8" that you are looking for. We do have the CE Smith Panel Bracket for 12" Boat Trailer Rollers #CE10305G and Roller…

view full answer...

Answer 7

The galvanized finish is better for salt water than your white powder coated wheels. If you want the best wheel for use in salt water you will want to use an aluminum wheel. I see that you were looking at the Loadstar ST175/80D13 Bias Trailer Tire…

view full answer...

Answer 8

In height or total diameter, a 185/80-13 and 175/80-13 like part #AM1ST77 only differ by about 5/8 of an inch. The 185 would have a diameter of 24.65 inches while the 175 would have a diameter of 24.02 inches. The section width, or thickness of the…

view full answer...

Answer 9

You just need to pack the bearings on hub and drum assembly #8-276-5. There's no such thing as too much grease for bearings! If it is an EZ lube hub with a grease zerk fitting at the end of the spindle you will know there is enough grease once it…

view full answer...

Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching