Can a 7,000LB Replacement Gear Kit Be Used On a 5,000LB A-Frame Jack?
Question:
Gears in my 5K jack are worn, is there a heavier gauge gear I can put in ?
asked by: Diana B
0
Expert Reply:
You can only replace the gears in your 5,000LB etrailer Round, A-Frame Jack # TJA-5000S-B with the 5,000LB rated Replacement Gear Kit for etrailer and Ram Sidewind Jacks # TJA-2000S-GR.
Heavier gauge gear kits will not work because the use larger diameter gears that will not fit your jack.
expert reply by:
Bud M
0
Products Referenced in This Question
Replacement Gear Kit for etrailer and Ram Sidewind Jacks - 2,000 lbs and 5,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- etrailer
more information >
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Alternative Ways to Power the Ultra-Fab Electric A-Frame Jack
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Jacks
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Q&A: Wiring 3-Wire Breakaway Switch as Replacement for 2-Wire Switch
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Q&A: Replacement Grease Seal for Lippert 3,500 Lb Axle SN: 045-002688794