Spacers for Timbren Suspension Enhancement System on 2022 Ford F-350
Question:
I purchased from etrrailer and installed the Timbren Suspension Enhancement System for the rear axle, part number TFRTT350J on a 2022 Ford F350 . There is a gap between the jounce stop and axle contact point greater than I expected for when no load is on the truck. The instructions state "There should be a ½” to 1 ½” gap between rubber spring and axle to ensure unloaded ride quality". I also see that this larger gap spacing is not that uncommon from reading online forums. Many are suggesting that you can easily resolve this issue using taller or additional spacers. My question is, can you stack these? My gap is a little over 2' so I need about 1 ½” of spacer thickness.
asked by: Trevor
Expert Reply:
Yes, you can stack the 1 inch spacer, # A25723-90AH00 and the 1/2 inch spacer, # TA25723-90AD00 but you will most likely need to replace the hardware too. I suggest you source this locally, purchase Grade 8 hardware, and simply buy one 1-1/2" longer than current bolt.
Products Referenced in This Question
Timbren 1" Spacer For Raised Frame Vehicles - 3/8" Bushing
- Accessories and Parts
- Vehicle Suspension
- Spacers
- Timbren
more information >
Timbren 1" Spacer For Raised Frame Vehicles - 1/2" Bushing
- Accessories and Parts
- Vehicle Suspension
- Spacers
- Lift Spacers
- Timbren
more information >
Product Page this Question was Asked From
Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Extra Heavy Duty
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Shop: Timbren Suspension Enhancement System - Rear Axle
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Shop: Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU - 16" x 16" Door
- Shop: LaSalle Bristol Street Elbow Fitting for RV Sewer System - ABS Plastic - 90 Degree - 1-1/2"
- Shop: TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375 lbs - White Bracket
- Shop: Victory Step Manual Fold-Down Steps for RV and Toy Hauler Patios - 4 Steps
- Shop: Westin Custom Fit Truck Bed Mat - Rubber - Black
- Q&A: How Tall are The Timbren Kits that Fit 2020 Ford F-250
- Q&A: Best Timbren Suspension Enhancement System for a 2017 Ford F-250 with Truck Bed Camper
- Q&A: Timbren Jounce Spring Clearance to Axle in Ford F-250
- Q&A: How Much Space Is Needed To Install The Timbren TFRTT350J On A 2022 Ford F-250 With An In-Bed Camper
- Q&A: Spacer Kit for Timbren Kit that Fits 2021 Ford F-350
- Search Results: camper turnbuckles
- Search Results: camper tie~downs
- Video: TorkLift SpringLoad XL Turnbuckles Review
- Video: Review of HappiJac Camper Tie-Downs - LC182900
- Video: Timbren Vehicle Suspension - Rear Axle Suspension Enhancement - TFRTT350J Review
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How To Mount TorkLift GlowStep Stow N' Go Steps To Camper With 9" Deep Bumper
- Q&A: Timbren Suspension Enhancement for 2019 Ford F-350
- Video: Review of TorkLift RV and Camper Steps - Truck Camper Scissor Steps - TLA7844
- Search Results: tla7621
- Search Results: tla7844
- Video: Review of Lippert Components Toy Hauler and Camper Steps - Patio Party Deck Stairs - LC726895
- Video: Review of Timbren Vehicle Suspension - Front Axle Suspension Enhancement - TFF350SDC
- Video: Timbren Front Suspension Enhancement System Review
- Shop: Roof Rack
- Search Results: cargo carrier
- Search Results: cargo rack