Does Derale Transmission Cooler Install Require Teflon Tape

Question

Question:

Purchase Derale Transmission Line Compression Fitting Kit with tran cooler.Do the threads need teflon tape for installation?

asked by: Dana H

0

Expert Reply:

I would not recommend using Teflon tape with Derale transmission cooler installs or with compression fittings like part # D13032. They aren't needed if the fittings are tightened down properly and if for some reason if the tape was to break off and get into the transmission fluid it might negatively affect the transmission.

expert reply by: Jameson C

0

Answer 1

When installing a transmission cooler, it is always a good idea to install the largest cooler that will fit in the space available on your truck. Transmission fluid cannot be over-cooled, however, if you live in a typically cold climate, it is a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

Thanks for reaching out, Scott! The Blue Ox Base Plate Kit #BLU74FR on our site is actually the same thing as the Blue Ox part number BX2418 and I like that removable pin style much more than the etrailer Classic Base Plate Kit #e98945 with the fixed…

view full answer...

Does Derale Transmission Cooler Install Require Teflon Tape

Product Page this Question was Asked From

Continue Researching