Cooling Fan on the Progressive Dynamics RV Power Control Center, PD4135

Question:

When charging the 12 volt lithium battery bank 2 x 100 ah, the heat sink seems excessively hot after a short period of time so the cooling fan seems to run after only charging for 10 minutes or so. Is this normal for the smart charging system? Also, I have the +12vDC side of the converter/charger side wired to a distribution panel located after the battery shut off switch where the battery bank also is connected. Should I wire the converter directly into the battery bank and bypass the distribution panel?

asked by: Pete K

Expert Reply:

If you are under load to charge a battery bank it is not unusual for the cooling fan on your Progressive Dynamics RV Power Control Center, # PD4135K to be running. Your converter has up to a 35 amp output for DC charging. It is important that you have plenty of circulation available.

Without seeing a wiring schematic it is challenging for me to identify if your installation is acceptable. The manufacturers installation instructions do state to connect the Battery POS lead to the F1 lead.

expert reply by: Michael R