Mounting Hole Specs for Gen-Y Hitch Torsion Pintle Hook Mounting Plate
Question:
Hi, what are the hole spacings on the contact plate and the diameter of bolt suggested.
asked by: Scott K
0
Expert Reply:
The mounting holes on the surface of the Gen-Y Torsion Pintle Hook Mounting Plate for 2" Hitches # 325-GH-1201 measure 1-3/4" up and down and then 3-3/8" side to side. Those are taken center on center. The mounting holes also have a 5/8" diameter.
Attached is a video showing the distances and a photo to further demonstrate this.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Gen-Y Torsion Pintle Hook Mounting Plate for 2" Hitches - 14 Hole - 16,000 lbs
- Pintle Hitch
- Pintle Mounting Plate
- 16000 lbs GTW
- 2 Inch Hitch Mount
- 14 Holes
- Cushioned Shank
- Gen-Y Hitch
more information >
Continue Researching
- Article: Pintle-Hitches
- Q&A: What Size Lunette Ring Will the Buyers Products 30 Ton Pintle Hook Fit
- Q&A: Mounting Kit Recommendation for 60k Buyers Products Pintle Hook
- Q&A: Adapter Solution for Going from Military 12 Pin Trailer Connector to Standard 4 or 7-Way
- Q&A: Solution for Using 12-Pin Trailer Connector With Vehicle 7-Way On M1102 Military Trailer
- Q&A: Accessories For Curt Rebellion XD For Pulling Wagons
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Pintle Hook And Mount With 8 - 10 Inch Rise
- Q&A: Can Dimmer be Used with Gustafson RV Puck Light # 277-000343
- Article: Determining Trailer Tongue Weight
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Article: Performance Chips and Modules