Can The Marlboro Continuous Hinge # MA64ZR Be Cut Down
Question:
Can this be cut down? My door is 5.5’ tall and has a 45 degree cut on the end to match the top part of frame
asked by: Randy R
0
Expert Reply:
If you wanted to cut down the 2" Wide Continuous Hinge # MA64ZR you would want to first remove the pin and separate each part and then cut them. You'll be better off cutting it at the end of the hinge loops, like I have pictured below, instead of trying to cut through them.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
2" Wide Continuous Hinge - 6' Long - 3/16" Pin Diameter - Aluminum
- Trailer Door Hinges
- Barrel Hinge
- Continuous Hinge
- Greasable Pin
- Aluminum
- 72 Inch Long
- 3/16 Inch Diameter
- 2 Inch Wide
- Weld-On
- Marlboro
more information >
Continue Researching
- Q&A: Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS
- Q&A: Backup Camera System Used with Factory Monitor on a Ram 3500
- Q&A: Trimming Photos for Installing 2022 GMC Canyon Curt Base Plate Kit
- Q&A: Available T-Handle Door Lock for 1-Inch Thick Door
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can A Weight Distribution Hitch Equalizer Be Used On A 2021 Honda Passport Touring AWD?
- Q&A: Lithium Battery Compatibility With Progressive Dynamics Pure Sine Wave Inverter With Transfer Switch
- Q&A: How to Empty Holding Tank on Dometic 972 Series Portable Camping Toilet
- Article: Trailer Maintenance Schedule
- Article: How to Replace or Install an RV Roof Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Measuring a Trailer Tire
- Article: How to Install E-Track in 3 Easy Steps
- Article: Stability Control for Heavy Duty Vehicles