Opening Dimensions for the Trailer Valet Replacement Crank Assembly
Question:
Will this work for my 1998 Dutchmen pop-up camper?
asked by: Daphne P
0
Expert Reply:
We haven't tested it, but I can tell you the size of the opening and the distance to that pin hole for the Replacement Crank Assembly # TV0006.
The opening is 1.5 cm square and then from the opening to the center of the pin hole is slightly over 2 cm. I confirmed this with my contact at Trailer Valet.
While this is designed to fit a Trailer Valet product, if it matches the specs that you're needing you should be able to use it just fine to operate your pop-up camper.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Crank Assembly for Trailer Valet Swivel Jack and Trailer Mover
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Trailer Valet
more information >
Continue Researching
- Q&A: What do the Hub Face and Spring Center Measurements Mean for an Axle
- Q&A: Idler Trailer Axle Placement On a Tandem Axle Trailer
- Q&A: How to Determine 5 Lug Bolt Pattern for 14 inch Wheel Based on Stud to Stud Dimension
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Hardware Recommendation for Securing E Tracks to Plywood Trailer Floor
- Q&A: Recommendations for Anchoring E-Track to a Ply-Wood Trailer Floor
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Q&A: What Does Ultra-Fab Electric A-Frame Jack Use as Manual Crank
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Jacks