How To Wire LED License Plate Light bracket LPL55CB To Exiting 4-way Trailer Connector On Vehicle
Question:
What would be done with the green and yellow wires, since they are not needed to power the LED License Plate Light?
asked by: Chris
Expert Reply:
I would be happy to help!
To install the Optronics LED Trailer License Plate Bracket # LPL55CB on your 2018 Subaru Outback Wagon and power it through your current trailer connector you will just need to get a trailer end 4-way connector # 18004.
You will connect the black wire from the bracket light to the brown wire on the 4-way connector, and the white wire from the bracket light to the white wire on the 4-way connector using heat shrink butt connectors # DW05744-5.
Keep in mind that if you ever go to tow a trailer you will have to unplug the harness which will leave you without a license plate light. So if you will be towing a trailer at any time you would be better off grounding the white wire from the license plate bracket to the frame of your vehicle, and running the black wire to the running light circuit (Brown Wire) of your trailer connector using a quick splice # SWC502905-1 to make the connection. If you need additional wire you can use # 16-1-1.
Doing the install this way will allow you to not use your trailer connector so you can still tow a trailer if needed.
I included a few video reviews of the products mentioned for you to take a look at.
Products Referenced in This Question
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Quick Splices - Self-Stripping Connector - Closed Port - 14-16-18 Gauge - Blue - Qty 1
- Wiring
- Wire Connectors
- Quick Splice Connectors
- 18-16-14 Gauge
- Spectro
more information >
Product Page this Question was Asked From
Optronics LED Trailer License Plate Light w/ Bracket - 5 Diodes - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 8-5/8L x 3-1/4W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: Trailer Wiring Diagrams
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Tire Sizing
- Q&A: Does Trailer Breakaway Battery have to be Charged for Truck to Sense Trailer Connection
- Q&A: Can Trailer Be Towed if Battery in Breakaway Kit is Dead
- Q&A: Can the Trailer Breakaway Battery be Used to Power a 12 Volt Interior Light
- Q&A: What is the Function for the 3 Wires Coming out of the Charger
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Article: How Long Can You Boondock in an RV?
- Article: Trailer Lighting Requirements
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Gooseneck Trailer Hitch Information and Review
Chris
9/22/2021
What would be done with the green and yellow wires, since they are not needed to power the LED License Plate Light?