How Does the Replacement Winch Spring Attach to a Fulton T2605
Question:
how does the ratchet spring fit ? do u have a pic to refer to thks , Leo
asked by: Leo M
1
Helpful Expert Reply:
The Replacement Spring for Fulton Winch # 4769-28 for your Fulton T2605 is definitely not the easiest thing to get installed, but I do have a picture below that will show how it is done. You will need to remove the bolt holding the ratchet pawl in place, but be sure to note how it came apart. There will be about 7 pieces total once removed and can be a pain to put back together.
expert reply by:
Lazer S
1
Fulton Replacement Ratchet Spring
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Fulton High-Performance 2-Speed Trailer Winch - Rope Only - Zinc - 2,600 lbs
- Trailer Winch
- Standard Hand Winch
- Boat Trailer Winch
- Utility Winch
- Heavy Duty
- Standard Hand Crank
- Two Speed Winch
- Wire Rope
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Are There Replacement Parts For 3,200 lb Fulton F2 Fully Enclosed, 2-Speed Trailer Winch
- Q&A: Dimensions of Base of Fulton Winch F142410
- Q&A: Difference Between the Fulton F142400 and F142401 Winches
- Q&A: Can Yakima Rack and Roll Trailer be Backed Into Water
- Q&A: How To Determine Fit of the 3,200 Lb 2-Speed Boat Trailer Winch
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Recommended Surge Brake Actuator To Replace Discontinued Atwood 61101 on Pacific Boat Trailer
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Boat Trailer Guides: Which are the Best?
- Article: Finding the Right Electric Winch
- Article: Hand Winches
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub