Does Bumper Fascia Need to Get Trimmed to Install Curt # C11333
Question:
Replacement bumper guide is in one piece across where you cut plastic fascia. Do I need to cut it??
asked by: Kip S
0
Expert Reply:
You do need to trim the rear fascia to install the Curt hitch part # C11333. Here's the description on what gets trimmed:
Measure to find the center of the fascia, mark the area to be trimmed. Trim center of bumper fascia as shown approximately 2 1/4" wide by 4 1/2" long. Carefully trim fascia.
You can see a picture of this in the attached instructions.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch for 2014 Mini Cooper Hardtop, Single Exhaust
- Q&A: Comparing a Folding Carrier and a Fixed Carrier for Trailer Hitch on a 2017 Toyota Highlander
- Q&A: Install Pictures of the Curt Hitch part # C11333
- Q&A: Is Trimming Required for Draw-Tite Hitch On 2016 Mini Countryman
- Q&A: Correct Trailer Hitch Fit for a 2016 Mini Countryman S ALL4
- Article: Rooftop Cargo Carriers
- Article: Can You Flat Tow a Subaru Crosstrek?
- Article: How to Choose a Bike Rack for a Sedan or Hatchback
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Ground Clearance of Curt Hitch When Installed on 2015 Mini Countryman
- Q&A: Parts Needed to Flat-Tow a 2015 Ford C-Max
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose a High-Low Adapter