Are There Two 5 foot Roller Bunks Included With the Boat Trailer Deluxe Roller Bunks

Question

Question:

could you tell me if there are two bunks included? thanks

asked by: ed r

0

Expert Reply:

Yes, a pair of 5 foot bunks (2) are included with the Boat Trailer Deluxe Roller Bunk - 5' Long - 12 Sets of 3 Rollers - by Dutton-Lainson, item # DL21741,

expert reply by: Robert G

0

Answer 1

Though we do not have an option that would have a perfect 90 degree angle, I may still have something that would work. The CE Smith #CE27610 is a little smaller and typically installed on the outside of a trailer frame, but can be used however…

view full answer...

Answer 2

Yes, you can use Roller Bunks #CE27700 with a pontoon boat trailer. These come in 4' long sections that you can attach directly on top of the bunk boards or you can use the V-Wing Bolster Bracket #CE26244G if you are concerned with raising…

view full answer...

Answer 3

These Boat Trailer Roller Bunks #DL21741 can be used in a variety of applications and installing them on your 22 foot pontoon trailer is a viable option as well. The only aspect that needs consideration is that these have a 3000 lb capacity per…

view full answer...

Answer 4

It sounds like you are trying to bring the boat down closer to the trailer frame. I have personally not seen many setups that involve using keel rollers like the CE Smith Deep V Keel Roller Assembly part #CE10455G with a pontoon boat but if you…

view full answer...

Answer 5

A couple sets of the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 will drastically help with getting your pontoon boat on and off the trailer smoothly and easily as there isn't any…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 8

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 9

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 10

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Are There Two 5 foot Roller Bunks Included With the Boat Trailer Deluxe Roller Bunks

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching